ماژول ترمیستور سوکت دار ۱۰۰K NTC

ماژول ترمیستور سوکت دار ۱۰۰K NTC


۱۱,۰۰۰ تومان

ناموجود

نقد و بررسی : ماژول ترمیستور سوکت دار ۱۰۰K NTC

ماژول ترمیستور ۱۰۰K NTC 3950

ماژول ترمیستور Thermistor 100K NTC 3950 با کابل

در پرینتر سه بعدی دما و تنظیم دقیق آن بسیار مهم است زیرا که اگر دما به صورت دقیق در محدوده ای خاص تنظیم نشود کیفیت چاپ به شدت کاهش میابد. از ترمیستور که یک سنسور دما با توانایی تحمل دمای بالای ۲۰۰ درجه میباشد برای تنظیم دقیق دمای نازل و هیت بد دستگاه استفاده میشود.
معمولا در ۲ قسمت از این قطعه استفاده می شود . یکی در کنار نازل تا دمای آن به طور پیوسته ثابت بماند. و دیگری در سطح heated bed(هیت بد) تا دمای محیط و کف قطعه در حال پرینت ثابت باشد.

این ترمستور همراه با کابل به متراژ یک متر می باشد

In most RepRaps, a thermistor senses the temperature of the Hot End. Often a second thermistor senses the temperature of theHeated Bed.
Thermistors are resistors that change of resistance with a change in temperature. Good qualities of thermistors are a predictable, accurately known resistance value at every temperature in its operating range. The lowering, or rise, depends on the type of thermistor per degree Kelvin (or Celcius, if you prefer), this is called its coefficient. Positive thermal coefficient (PTC) will increase in resistance with an increase in temperature, negative ones (NTC) will decrease. But the formula in practice is not linear, so sometimes an accurate table of measurements is better than the linear formula. These measurements can usually be found in the datasheet that accompanies the thermistor

ماژول ترمیستور ۱۰۰K NTC 3950

ماژول ترمیستور ۱۰۰K NTC 3950

نقد وبررسی

نقد بررسی یافت نشد...

اولین نفر باشید که نقد و بررسی ارسال میکنید... “ماژول ترمیستور سوکت دار ۱۰۰K NTC”

این سایت از اکیسمت برای کاهش هرزنامه استفاده می کند. بیاموزید که چگونه اطلاعات دیدگاه های شما پردازش می‌شوند.

enemad-logo